Working voltage: 2.7-4.2V

Output current: 0-3Amp

Over-heated protection: 55-60 degree

Low voltage protection: 2.7V

Working modes: 100%-50%-10%-10Hz Strobe-SOS (Magnet rotating 30 degree, mode will change)

Magnetic control angle: 30 degree

Magnet size: 3 x 3 x 2mm

Magnetic induction distance: 1-5mm

Total height: 8mm (Single lithium electric version)

Diameter: 21.2mm

Connecting methods: 

White line to LED+, Black line to LED-. Battery positive line to the mid of board, 

negative line to the shell. Please pay attention to the Insulation and heat dissipation, otherwise will burn 

out the LED or the driver. Before installation, please check if the driver and LED is in good condition.

Attention: 

One piece Circuit Board with 3~4 pieces "Thermally conductive adhesive". 

To make it better to thermally conductive, please smash the "Thermally conductive 

adhesive" and filled it between circuit board and body.