jusval,Reviews(6),Post(1),01/11/2009 |
|
 It is a good board
|
Strengths:Two of the 7135s hooked together, is just waht is needed for the Seoul P7. It came packaged very well.
Weaknesses:One hope is that the people making these boards will leave out the wires. It needs to have High Temp Teflon wires on it and I had to replace the wires sent. The solder has gotten better, but you still need to "clean up" the excess soldering and I still had to solder across Q1 & Q3.
Summary:If the board is supposed to be for the P7, then Q1 & Q3 need to be bridged when it comes. I can only think that the makers don't want to send out boards that are maxed out at 2.8ma. The way it came it was 1400ma and my P7 would have been severely limited in output. It's still far cheaper than anything else out there and it can be used once modded.
|
|
Lupis,Reviews(16),Post(1),02/12/2009 |
|
|
Works if you fix it
|
Strengths:Appeared good quality.
Weaknesses:Does not ship as pictured. You have to clean up some solder, and make a connection to get the right output.
Summary:I am still not sure if I got it right. I would not buy these again.
|
|